Cisco WS-C3560E-48PD-SF Command Reference - Page 157
ip address
View all Cisco WS-C3560E-48PD-SF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands ip address ip address Use the ip address interface configuration command to set an IP address for the Layer 2 switch or an IP address for each switch virtual interface (SVI) or routed port on the Layer 3 switch. Use the no form of this command to remove an IP address or to disable IP processing. ip address ip-address subnet-mask [secondary] no ip address [ip-address subnet-mask] [secondary] Syntax Description ip-address subnet-mask secondary IP address. Mask for the associated IP subnet. (Optional) Specifies that the configured address is a secondary IP address. If this keyword is omitted, the configured address is the primary IP address. Defaults No IP address is defined. Command Modes Interface configuration Command History Release 12.1(19)EA1 Modification This command was introduced. Usage Guidelines If you remove the switch IP address through a Telnet session, your connection to the switch will be lost. Hosts can find subnet masks using the Internet Control Message Protocol (ICMP) Mask Request message. Routers respond to this request with an ICMP Mask Reply message. You can disable IP processing on a particular interface by removing its IP address with the no ip address command. If the switch detects another host using one of its IP addresses, it will send an error message to the console. You can use the optional keyword secondary to specify an unlimited number of secondary addresses. Secondary addresses are treated like primary addresses, except the system never generates datagrams other than routing updates with secondary source addresses. IP broadcasts and ARP requests are handled properly, as are interface routes in the IP routing table. Note If any router on a network segment uses a secondary address, all other devices on that same segment must also use a secondary address from the same network or subnet. Inconsistent use of secondary addresses on a network segment can very quickly cause routing loops. When you are routing Open Shortest Path First (OSPF), ensure that all secondary addresses of an interface fall into the same OSPF area as the primary addresses. 78-16405-05 Catalyst 3560 Switch Command Reference 2-125