Cisco WS-C3560E-48PD-SF Command Reference - Page 264

match (access-map configuration) Chapter 2 Catalyst 3560 Switch Cisco IOS Commands match (access-map configuration) Use the match access-map configuration command to set the VLAN map to match packets against one or more access lists. Use the no form of this command to remove the match parameters. match {ip address {name | number} [name | number] [name | number]...} | {mac address {name} [name] [name]...} no match {ip address {name | number} [name | number] [name | number]...} | {mac address {name} [name] [name]...} Syntax Description ip address mac address name number Set the access map to match packets against an IP address access list. Set the access map to match packets against a MAC address access list. Name of the access list to match packets against. Number of the access list to match packets against. This option is not valid for MAC access lists. Defaults The default action is to have no match parameters applied to a VLAN map. Command Modes Access-map configuration Command History Release 12.1(19)EA1 Modification This command was introduced. Usage Guidelines You enter access-map configuration mode by using the vlan access-map global configuration command. You must enter one access list name or number; others are optional. You can match packets against one or more access lists. Matching any of the lists counts as a match of the entry. In access-map configuration mode, use the match command to define the match conditions for a VLAN map applied to a VLAN. Use the action command to set the action that occurs when the packet matches the conditions. Packets are matched only against access lists of the same protocol type; IP packets are matched against IP access lists, and all other packets are matched against MAC access lists. Both IP and MAC addresses can be specified for the same map entry. 2-232 Catalyst 3560 Switch Command Reference 78-16405-05