Cisco WS-C3560E-48PD-SF Command Reference - Page 773

Appendix B Catalyst 3560 Switch Debug Commands debug ip dhcp snooping debug ip dhcp snooping Use the debug ip dhcp snooping privileged EXEC command to enable debugging of DHCP snooping. Use the no form of this command to disable debugging. debug ip dhcp snooping {mac-address | agent | event | packet} no debug ip dhcp snooping {mac-address | agent | event | packet} This command is available only if your switch is running the IP services image, formerly known as the enhanced multilayer image (EMI). Syntax Description mac-address agent event packet Display debug messages for a DHCP packet with the specified MAC address. Display debug messages for DHCP snooping agents. Display debug messages for DHCP snooping events. Display debug messages for DHCP snooping. Defaults Debugging is disabled. Command Modes Privileged EXEC Command History Release 12.2(20)SE Modification This command was introduced. Usage Guidelines The undebug ip dhcp snooping command is the same as the no debug ip dhcp snooping command. Related Commands Command show debugging Description Displays information about the types of debugging that are enabled. For syntax information, select Cisco IOS Release 12.2 Configuration Guides and Command References > Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.2 > System Management > Troubleshooting and Fault Management. 78-16405-05 Catalyst 3560 Switch Command Reference B-13