Cisco WS-C3560E-48PD-SF Command Reference - Page 239

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands logging event power-inline-status logging event power-inline-status Use the logging event power-inline-status interface configuration command to enable the logging of Power over Ethernet (PoE) events. Use the no form of this command to disable the logging of PoE status events; however, the no form of this command does not disable PoE error events. logging event power-inline-status no logging event power-inline-status Syntax Description power-inline-status Enable the logging of PoE messages. Defaults Logging of PoE events is enabled. Command Modes Interface configuration Command History Release 12.1(19)EA1 Modification This command was introduced. Usage Guidelines The power-inline-status keyword is available only on PoE interfaces. Examples This example shows how to enable logging of PoE events on a port: Switch(config-if)# interface fastethernet0/1 Switch(config-if)# logging event power-inline-status Switch(config-if)# Related Commands Command power inline show controllers power inline Description Configures the power management mode for the specified PoE port or for all PoE ports. Displays the values in the registers of the specified PoE controller. 78-16405-05 Catalyst 3560 Switch Command Reference 2-207