Cisco WS-C3560E-48PD-SF Command Reference - Page 27

CH A P T E R 1 Using the Command-Line Interface The Catalyst 3560 switch is supported by Cisco IOS software. This chapter describes how to use the switch command-line interface (CLI) to configure software features. For a complete description of the commands that support these features, see Chapter 2, "Catalyst 3560 Switch Cisco IOS Commands." For information on the boot loader commands, see Appendix A, "Catalyst 3560 Switch Boot Loader Commands." For information on the debug commands, see Appendix B, "Catalyst 3560 Switch Debug Commands." For information on the show platform commands, see Appendix C, "Catalyst 3560 Switch Show Platform Commands." For more information on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command Summary. For task-oriented configuration steps, see the software configuration guide for this release. In this document, IP refers to IP version 4 (IPv4) unless there is a specific reference to IP version 6 (IPv6). CLI Command Modes This section describes the CLI command mode structure. Command modes support specific Cisco IOS commands. For example, the interface interface-id command only works when entered in global configuration mode. These are the main command modes for the switch: • User EXEC • Privileged EXEC • Global configuration • Interface configuration • Config-vlan • VLAN configuration • Line configuration 78-16405-05 Catalyst 3560 Switch Command Reference 1-1