Cisco WS-C3560E-48PD-SF Command Reference - Page 306

mls qos vlan-based Chapter 2 Catalyst 3560 Switch Cisco IOS Commands mls qos vlan-based Use the mls qos vlan-based interface configuration command to enable VLAN-based quality of service (QoS) on the physical port. Use the no form of this command to disable this feature. mls qos vlan-based no mls qos vlan-based Syntax Description There are no arguments or keywords. Defaults VLAN-based QoS is disabled. Command Modes Interface configuration Command History Release 12.2(25)SE Modification This command was introduced. Usage Guidelines Before attaching a hierarchical policy map to a switch virtual interface (SVI), use the mls qos vlan-based interface configuration command on a physical port if the port is to be specified in the secondary interface level of the hierarchical policy map. When you configure hierarchical policing, the hierarchical policy map is attached to the SVI and affects all traffic belonging to the VLAN. The individual policer in the interface-level traffic classification only affects the physical ports specified for that classification. For detailed instructions about configuring hierarchical policy maps, see the "Classifying, Policing, and Marking Traffic by Using Hierarchical Policy Maps" section in the software configuration guide for this release. Examples This example shows how to enable VLAN-based policing on a physical port: Switch(config)# interface gigabitethernet0/1 Switch(config-if)# mls qos vlan-based You can verify your settings by entering the show mls qos interface privileged EXEC command. Related Commands Command show mls qos interface Description Displays QoS information. 2-274 Catalyst 3560 Switch Command Reference 78-16405-05