Cisco WS-C3560E-48PD-SF Command Reference - Page 355

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands rcommand rcommand Use the rcommand user EXEC command to start a Telnet session and to execute commands on a cluster member switch from the cluster command switch. To end the session, enter the exit command. rcommand {n | commander | mac-address hw-addr} Syntax Description n commander mac-address hw-addr Provide the number that identifies a cluster member. The range is 0 to 15. Provide access to the cluster command switch from a cluster member switch. MAC address of the cluster member switch. Command Modes User EXEC Command History Release 12.1(19)EA1 Modification This command was introduced. Usage Guidelines This command is available only on the cluster command switch. If the switch is the cluster command switch but the cluster member switch n does not exist, an error message appears. To get the switch number, enter the show cluster members privileged EXEC command on the cluster command switch. You can use this command to access a cluster member switch from the cluster command-switch prompt or to access a cluster command switch from the member-switch prompt. For Catalyst 2900 XL, 3500 XL, 2950, 2960, 2970, 3550, 3560, and 3750 switches, the Telnet session accesses the member-switch command-line interface (CLI) at the same privilege level as on the cluster command switch. For example, if you execute this command at user level on the cluster command switch, the cluster member switch is accessed at user level. If you use this command on the cluster command switch at privileged level, the command accesses the remote device at privileged level. If you use an intermediate enable-level lower than privileged, access to the cluster member switch is at user level. For Catalyst 1900 and 2820 switches running standard edition software, the Telnet session accesses the menu console (the menu-driven interface) if the cluster command switch is at privilege level 15. If the cluster command switch is at privilege level 1, you are prompted for the password before being able to access the menu console. Cluster command switch privilege levels map to the cluster member switches running standard edition software as follows: • If the cluster command switch privilege level is from 1 to 14, the cluster member switch is accessed at privilege level 1. • If the cluster command switch privilege level is 15, the cluster member switch is accessed at privilege level 15. The Catalyst 1900 and 2820 CLI is available only on switches running Enterprise Edition Software. 78-16405-05 Catalyst 3560 Switch Command Reference 2-323