Cisco WS-C3560E-48PD-SF Command Reference - Page 417

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands show dot1x AuthFail-Vlan = 1001 AuthFail-Max-Attempts = 3 Critical Port = Enabled This is an example of output from the show dot1x statistics interface interface-id command. Table 2-22 describes the fields in the display. Switch# show dot1x statistics interface gigabitethernet0/1 PortStatistics Parameters for Dot1x TxReqId = 15 TxReq = 0 TxTotal = 15 RxStart = 4 RxLogoff = 0 RxRespId = 1 RxResp = 1 RxInvalid = 0 RxLenErr = 0 RxTotal= 6 RxVersion = 1 LastRxSrcMac 00d0.b71b.35de Table 2-22 show dot1x statistics Field Descriptions Field TxReqId TxReq TxTotal RxStart RxLogoff RxRespId RxResp RxInvalid RxLenError RxTotal RxVersion LastRxSrcMac Description Number of Extensible Authentication Protocol (EAP)-request/identity frames that have been sent. Number of EAP-request frames (other than request/identity frames) that have been sent. Number of Extensible Authentication Protocol over LAN (EAPOL) frames of any type that have been sent. Number of valid EAPOL-start frames that have been received. Number of EAPOL-logoff frames that have been received. Number of EAP-response/identity frames that have been received. Number of valid EAP-response frames (other than response/identity frames) that have been received. Number of EAPOL frames that have been received and have an unrecognized frame type. Number of EAPOL frames that have been received in which the packet body length field is invalid. Number of valid EAPOL frames of any type that have been received. Number of received packets in the IEEE 802.1x Version 1 format. Source MAC address carried in the most recently received EAPOL frame. Related Commands Command dot1x default Description Resets the IEEE 802.1x parameters to their default values. 78-16405-05 Catalyst 3560 Switch Command Reference 2-385