Cisco WS-C3560E-48PD-SF Command Reference - Page 205
ip igmp snooping vlan static
View all Cisco WS-C3560E-48PD-SF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands ip igmp snooping vlan static ip igmp snooping vlan static Use the ip igmp snooping static global configuration command to enable Internet Group Management Protocol (IGMP) snooping and to statically add a Layer 2 port as a member of a multicast group. Use the no form of this command to remove ports specified as members of a static multicast group. ip igmp snooping vlan vlan-id static ip-address interface interface-id no ip igmp snooping vlan vlan-id static ip-address interface interface-id Syntax Description vlan-id ip-address interface interface-id Enable IGMP snooping on the specified VLAN. The range is 1 to 1001 and 1006 to 4094. Add a Layer 2 port as a member of a multicast group with the specified group IP address. Specify the interface of the member port. The keywords have these meanings: • fastethernet interface number-a Fast Ethernet IEEE 802.3 interface. • gigabitethernet interface number-a Gigabit Ethernet IEEE 802.3z interface. • port-channel interface number-a channel interface. The range is 0 to 48. Defaults By default, there are no ports statically configured as members of a multicast group. Command Modes Global configuration Command History Release 12.1(19)EA1 Modification This command was introduced. Usage Guidelines VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP snooping. The configuration is saved in NVRAM. Examples This example shows how to statically configure a host on an interface: Switch(config)# ip igmp snooping vlan 1 static 0100.5e02.0203 interface gigabitethernet0/1 Configuring port gigabitethernet0/1 on group 0100.5e02.0203 You can verify your settings by entering the show ip igmp snooping privileged EXEC command. 78-16405-05 Catalyst 3560 Switch Command Reference 2-173