Cisco WS-C3560E-48PD-SF Command Reference - Page 186

ip igmp filter Chapter 2 Catalyst 3560 Switch Cisco IOS Commands ip igmp filter Use the ip igmp filter interface configuration command to control whether or not all hosts on a Layer 2 interface can join one or more IP multicast groups by applying an Internet Group Management Protocol (IGMP) profile to the interface. Use the no form of this command to remove the specified profile from the interface. ip igmp filter profile number no ip igmp filter Syntax Description profile number The IGMP profile number to be applied. The range is 1 to 4294967295. Defaults No IGMP filters are applied. Command Modes Interface configuration Command History Release 12.1(19)EA1 Modification This command was introduced. Usage Guidelines You can apply IGMP filters only to Layer 2 physical interfaces; you cannot apply IGMP filters to routed ports, switch virtual interfaces (SVIs), or ports that belong to an EtherChannel group. An IGMP profile can be applied to one or more switch port interfaces, but one port can have only one profile applied to it. Examples This example shows how to apply IGMP profile 22 to a port: Switch(config)# interface gigabitethernet0/2 Switch(config-if)# ip igmp filter 22 You can verify your setting by using the show running-config privileged EXEC command and by specifying an interface. Related Commands Command Description ip igmp profile Configures the specified IGMP profile number. show ip igmp profile Displays the characteristics of the specified IGMP profile. show running-config interface interface-id Displays the running configuration on the switch interface, including the IGMP profile (if any) that is applied to an interface. For syntax information, select Cisco IOS Configuration Fundamentals Command Reference, Release 12.2 > File Management Commands > Configuration File Management Commands. 2-154 Catalyst 3560 Switch Command Reference 78-16405-05