Cisco WS-C3560E-48PD-SF Command Reference - Page 545
logging event, power-inline-status, power inline, show controllers, Table 2-30
View all Cisco WS-C3560E-48PD-SF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 545 highlights
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands show power inline Interface Admin Oper Power Device Class Max (Watts) Fa0/1 auto on 6.3 IP Phone 7910 n/a 15.4 This is an example of output from the show power inline consumption default command on all PoE switch ports: Switch> show power inline consumption default Default PD consumption : 15400 mW Table 2-30 Field Admin Oper Power Device Class Available Used Remaining show power inline interface Field Descriptions Description Administration mode: auto, off, static Operating mode: • on-the powered device is detected, and power is applied. • off-no PoE is applied. • faulty-device detection or a powered device is in a faulty state. • power-deny-a powered device is detected, but no PoE is available, or the maximum wattage exceeds the detected powered-device maximum. The supplied PoE in watts The device type detected: n/a, unknown, Cisco powered-device, IEEE powered-device, The IEEE classification: n/a, Class The total amount of PoE in the system The amount of PoE allocated to ports The amount of PoE not allocated to ports in the system. (Available - Used = Remaining) Related Commands Command logging event power-inline-status power inline show controllers power inline Description Enables the logging of PoE events. Configures the power management mode for the specified PoE port or for all PoE ports. Displays the values in the registers of the specified PoE controller. 78-16405-05 Catalyst 3560 Switch Command Reference 2-513