Yamaha AW4416 Owner's Manual - Page 140
Manual punch-in/out, Preparations
View all Yamaha AW4416 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Chapter7-Punch-in/out Manual punch-in/out Here's how to perform manual punch-in/out. Preparations ❒ Make input monitor settings For the track on which you wish to punch-in/out, you will need to monitor the track playback up to the punch-in point, and then monitor the input signal of the track (the recording source) after you punch-in. To do this, set the input monitor setting to "auto input monitor," as explained below. 1. Press the [TRACK] key ¡ [F1] key. Input monitor setting 2. In the INPUT MONITOR area, move the cursor to the AUTO button and press the [ENTER] key. The AUTO button will be turned on, and Auto Input Monitor will be selected as the input monitor setting. ❒ Connect a foot switch If you will be using a separately sold foot switch (Yamaha FC-5) to perform manual punch-in/out, connect the foot switch to the FOOT SW jack on the rear panel. If a foot switch other than the Yamaha FC-5 is connected, it may not operate correctly. 128 - Operation Guide