Yamaha AW4416 Owner's Manual - Page 196
Assigning the pad outputs to channels
View all Yamaha AW4416 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
Chapter12-Sampling pads Assigning the pad outputs to channels In order to use the sampling pads, you must first assign each pad output to an input channel 1-24. The output of a pad that is assigned to a channel can be controlled by attenuation, phase, EQ, and dynamics in the same way as a conventional input, and can be recorded on a track of the recorder. 1. Press the [SETUP] key ¡ [F1] key. The SETUP screen Patch In page will appear, allowing you to select the input signal for each input channel. MIXER CHANNEL INPUT ASSIGN area 2. In the MIXER CHANNEL INPUT ASSIGN area, move the cursor to the input channel to which you will assign the pad output. 3. Rotate the [DATA/JOG] dial to make a selection in the range of "SMP 1"- "SMP 8." The output of the selected pad will be assigned to the input channel. Tip! • Pad assignments are common to banks A and B. If "SMP 1" is selected for a channel, the output of pad 1 for both banks A and B will be assigned to it. • All sounds assigned to pads will be monaural output. 4. Turn on the [ON] key of the input channel to which the pad is assigned, and raise the fader. Now the signal of the pad you selected in step 3 will be sent to the corresponding input channel, and can be recorded or monitored. 186 - Operation Guide