Yamaha AW4416 Owner's Manual - Page 175
Internal effects, About the internal effects
View all Yamaha AW4416 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 175 highlights
10 Internal effects This chapter explains the two built-in effects of the AW4416. About the internal effects The AW4416 contains two multi-effect units (respectively called "effect 1" and "effect 2"). In general, the internal effects can be used in the following two ways. ❒ Using AUX send/return In this method, the two AUX sends are used to send signals from each channel to the inputs of effects 1/2, and the outputs of effects 1/2 are mixed with the signals of the stereo bus or buses 1-8. When the AW4416 is in the default state, AUX send 7/8 are patched to the inputs of effects 1/2, and the outputs of effects 1/2 are patched to return channels 1/2. The signals sent from input channels 1-24 and monitor channels 1-16 to AUX buses 7/8 are input to effects 1/2 respectively. For each channel, you can adjust the AUX 7/8 send levels and switch between pre- or post-fader. The output signals from effects 1/2 are sent to return channels 1/2. By routing the return channels to buses 1-8 or the stereo bus, they can be mixed with the original sound of each channel. ❒ Inserting an effect into a channel If you defeat the assignment of effect 1/2 to AUX send 7/8, you can insert an effect into the desired channel (immediately before the attenuator). In this case, the mixed effect and direct signals will be input to the corresponding channel. An effect that is used for insertion cannot be inserted into another channel, or used via send/return. Effects can be inserted into the following channels. • Input channels 1-24 • Monitor channels 1-16 • Return channels 1/2 • Stereo output channel 165 - Operation Guide