Yamaha AW4416 Owner's Manual - Page 61

Chapter2-Parts and their functions D INSERT I/O 1/2 jacks These are TRS phone jacks that allow an external effect etc. to be inserted into the input signal of INPUT jacks 1/2. Nominal input level is 0 dB. Pin connections are as follows. 1/4" phone plug Tip (OUT) OUT IN 1/4" TRS phone plug To the input jack of Sleeve (ground) the external processor Sleeve (ground) To the INSERT I/O jack of the AW4416 1/4" phone plug Tip (IN) To the output jack of the external processor Sleeve (ground) E INPUT 3-8 (phone) jacks These are balanced TRS phone type input jacks. The specifications are the same as for 3 INPUT 1/2 (phone) jacks. F INPUT 8 (HI-Z) jack This is a high impedance unbalanced phone type input jack. Instruments with a high output impedance such as passive type electric guitars can be directly connected here. Nominal input level is -46 dB- +4 dB. If plugs are inserted into both the normal INPUT 8 (BAL) jack and the INPUT 8 (HI-Z) jack, the INPUT 8 (HI-Z) jack will take priority. G 2.5" HARD DISK DRIVE slot This slot allows an IDE 2.5 inch hard disk to be installed. Note • For the procedure of installing the hard disk, refer to page 2. • For a list of manufacturers and models of hard disk that are known to work when installed in the AW4416, please refer to the website H OMNI OUT 1-4 jacks These are unbalanced phone jacks that output the analog signal assigned to OMNI OUT 1-4 in the SETUP screen ¡ Patch OUT page (¡ P.136). Nominal output level is 0 dB. I MONITOR OUT jacks These are balanced TRS phone jacks that output analog monitor signals such as the stereo bus, internal metronome, solo signal, or direct output from recorder tracks 1-16. Nominal output level is +4 dB. J STEREO OUT jacks These are unbalanced RCA phono jacks that output the analog signal assigned to ST OUT in the SETUP screen ¡ Patch OUT page (¡ P.136). Nominal output level is -10 dBV. 47 - Operation Guide