Yamaha AW4416 Owner's Manual - Page 5
Handling the CD-R/RW media, Operating Notes - recording
View all Yamaha AW4416 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Important • Do not touch the power plug with wet hands. Doing so is a potential electrical shock hazard. • Use only the included power supply cable for this unit. Using other types may be a fire hazard. • Always touch a well-grounded metal surface or the like to fully discharge any static electric charge on your body and clothing before handling an I/O card or hard disk. Neglecting this precaution can cause damage to the unit from static electricity. • Be careful not to touch the leads (metal feet) on the rear side when handling an I/O card or hard disk. Touching the leads can cause contact defects. ❒ Operating Notes • Using a mobile telephone near this unit may induce noise. If noise occurs, use the telephone away from the unit. • XLR-type connectors are wired as follows: pin 1: ground, pin 2: hot (+), and pin 3: cold (-). • Insert TRS phone jacks are wired as follows: sleeve: ground, tip: send, and ring: return. • If the message "LOW BATTERY" appears when you turn on this unit, contact your dealer as soon as possible about replacing the internal data backup battery. The unit will still operate correctly, but data other than the presets will be lost. We recommend that you save the data on CD-RW drive or external SCSI device before replacing the battery. • The performance of components with moving contacts, such switches, rotary controls, faders, and connectors, deteriorates over time. The rate of deterioration depends on the operating environment and is unavoidable. Consult your dealer about replacing defective components. Handling the CD-R/RW media Please observe the following points when handling the disk. Failure to do so may cause problems such as the recorded data being lost, the drive to malfunction, or the printed label to become blurred. • Do not place the disk in locations of direct sunlight, high temperature, or high humidity. • Do not touch either surface of the disk. • Hold the disk at the edges. Gently wipe dust or dirt off of the recording sur- face of the disk. • Do not wipe the disk with chemicals or detergents. • Do not bend or drop the disk. • Use an air duster or cleaner to remove dust. Vigorously rubbing the surface of the disk with a dry cloth may scratch the disk. • Do not write on the disk or affix labels to it. v - Operation Guide