Yamaha AW4416 Owner's Manual - Page 148
Patching to the outputs
View all Yamaha AW4416 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Chapter8-Patching Patching to the outputs When the AW4416 is in the default state, the following signals are assigned to the OMNI OUT jacks, STEREO OUT jacks, and digital I/O card outputs. If necessary, you can change the output signals that are assigned to these output jacks. Mixer section AUX buses 1-4 Stereo output channel Buses 1-8 Output patch ×4 ×2 ×2 ×8 ×8 OPTION I/O slot 1 OPTION I/O slot 2 OMNI OUT jacks 1-4 DIGITAL STEREO OUT jack STEREO OUT jacks I/O card I/O card Here's how to assign the desired signal to each output jack. 1. Press the [SETUP] key ¡ [F2] (Patch OUT) key. The display will show the SETUP screen Patch OUT page. The various fields of the display will show the patched status of each output jack. Tip! If the Patch OUT tab is not assigned to the [F2] key, press the [SHIFT] key + [F1] key to switch the tabs, and then press the [F2] key. 1 2 3 4 5 136 1 OMNI OUT jack 1-4 B DIGITAL STEREO OUT jack C STEREO OUT jack D OUTPUT 1-8 of an I/O card (slot 1) E OUTPUT 1-8 of an I/O card (slot 2) - Operation Guide