Brother International PE-DESIGN Ver.5 Users Manual - English - Page 225
Optimize hoop change, embroidery frame installation position is changed too often.
View all Brother International PE-DESIGN Ver.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 225 highlights
Contents Before Using Getting Started I Optimize hoop change Purpose: Optimizes the sewing order of patterns in a Design Page for multi-position embroidery frames (100 × 172 mm, 172 × 100 mm, 130 × 300 mm, or 300 × 130 mm) Shortcut key: No shortcut key for this function Toolbar: No button for this function Operation: 1 Click Sew, then Optimize hoop change. This setting can be turned on or off. A check mark appears when this setting is turned on; no check mark is displayed when this setting is turned off. When the Optimize hoop change setting is turned on: The sewing order that you have set is optimized 5 a to reduce the number of times that the embroi- dery frame installation position is changed. For the example shown at the right, the sewing order is: a (pattern 1) ¡ b (pattern 2) ¡ a (patterns 3 & 5) ¡ c (patterns 4 & 6) 3 1 When the Optimize hoop change setting is turned b 2 off: Each pattern is sewn according to the sewing 4 order that you have set. Therefore, since the num- ber of times for changing the embroidery frame installation position is not optimized, it may be changed more often than if it was optimized. 6 c For the example shown at the right, the sewing order is: a (pattern 1) ¡ b (pattern 2) ¡ a (pattern 3) ¡ c (pattern 4) ¡ a (pattern 5) ¡ c (pattern 6) NOTE: Depending on the pattern, turning on the Optimize hoop change setting may reduce the number of times that the embroidery frame installation position is changed. More importantly, it reduces the chances of the embroidery not being sewn correctly or the fabric becoming wrinkled when the embroidery frame installation position is changed too often. Design Center Layout & Editing Programmable Stitch Creator Quick Reference Alphabetic Index 217