Epson 2200 Service Manual - Page 103

EPSON Stylus PHOTO 2100/2200 Revision B Table 3-17. Phenomenon-Based Fatal Error Check Points Occurrence Timing Phenomenon Detail Faulty Part/Part Name Check Point Remedy At power-on In Cutter initialization operation, Cutter HP sensor 1. Check the Cutter HP sensor (left) and the rail groove of the Cutter 1. Remove the paper dust, foreign matter, etc. (At Cutter unit fitting) the Carriage produces operating (left) for paper dust, foreign matter, etc. from the Cutter HP sensor (left) and the rail noise at power-on. groove of the Cutter. Cutter HP sensor (left) During printing Before start of printing, initial filling is executed and printing is then started. Ink is not delivered and paper stops midway. Head FFC 2. Check that the connector cable of the Cutter HP sensor (left) is connected securely 3. Check the Cutter HP sensor (left) for damage. * The above check points 1 to 3 apply to the case where the Cutter is not in the right HP position. 2. Connect the connector cable of the Cutter HP sensor (left) to CN3 on the Driver board securely. 3. Change the Cutter HP sensor (left) for a new one. 1. Check that the Head FFC is connected to the Printhead and Main 1. Connect the Head FFC to the Printhead and board. Main board correctly. Ink is not delivered from most nozzles. Head FFC Printhead CN10 CN11 2. Check the Head FFC for damage. 1. Check for occurrence of Head Hot. 2. Change the Head FFC for a new one. 1. Change the Printhead for a new one. TROUBLESHOOTING Troubleshooting 103