Epson 2200 Service Manual - Page 32

EPSON Stylus PHOTO 2100/2200 PANEL OPERATION IN ROLL PAPER MODE (WITH CUTTER) To shift to the paper roll mode, use the roll paper mode selection command of the remote commands. Specify the cutting position of the roll paper using the cutting position specifying command of the remote commands. When the specified position comes to the cutting position, the paper is cut automatically. If the cutting position specifying command is not available for the roll paper, perform the "Panel operation in roll paper mode (Without cutter, tear-off line printing)" on Page 31. Operating procedure 1. Insert roll paper from the roll paper guide. *a 2. Receive the roll paper data and perform printing until the end of the job. If the cutting specified position reaches the cutter blade position during printing, the roll paper is cut. *b 3. Press the Roll paper switch to execute Tear Off cutting. Return from Tear Off is then performed automatically. *c Continued to the right field. With the Paper detection sensor on for 2 seconds, the roll paper is fed automatically. After the roll paper is fed, the operation with the Paper switch is masked. If consecutive print jobs come, the CR stops at the end of the last job and the printer does not eject nor cut the paper and enters the switch waiting status. At this time, there are no print margins between the jobs. If there is a next print jog, the printer prints and Steps 2. and 3. are repeated. Revision B Continued from the left field 4. Press the Roll paper switch for 3 seconds to back out the paper. *d 5. When the roll paper cannot back out any more, remove the roll paper with your hands. *d 6. Press the Roll paper switch or Paper switch to clear a paper jam. The printer returns to the normal mode. After back-out, the Paper LED blinks. The masked Paper switch is de-masked. If the roll paper cannot be removed after one back-out, press the Roll paper switch or Paper switch for 3 seconds to execute back-out again. The Paper LED goes off. *a : If power is switched off at this point, the panel feeding status is stored onto the EEPROM. When power is switched on again, the printer does not eject paper. The operation in Step 2. and later can be performed. *b : If power is switched off at this point, Tear Off is executed automatically to cut the roll paper, and the roll paper mode status is stored onto the EEPROM. When power is switched on again, the printer does not eject paper. The operation in Step 3. and later can be performed. *c : If power is switched off at this point, the roll paper mode status is stored onto the EEPROM. When power is switched on again, the printer does not eject paper. The operation in Step 3. and later can be performed. *d : If power is switched off at this point, the roll paper mode is canceled and the panel feeding cancel is stored. When power is switched on again next, the printer enters the normal mode if the Paper detection sensor is off. PRODUCTION DESCRIPTION Functions 32