Epson 2200 Service Manual - Page 93

EPSON Stylus PHOTO 2100/2200 Revision B Occurrence Timing Phenomenon Detail At roll paper feeding After the roll paper is fed, the by auto loading Paper LED indicates Blink 2. Table 3-14. Phenomenon-Based Cutter Jam Error Check Points Faulty Part/ Part Name Cutter motor Check Point Remedy 1. Check that the connector cable of the Cutter motor is connected to 1. Connect the connector cable of the Cutter CN2 on the Driver board correctly. motor to CN2 on the Driver board securely. Cutter motor Driver board At roll paper feeding When the roll paper is fed, the Cutter produces operating noise. At roll paper cutting When the roll paper is cut, the paper is cut only halfway. CN2 2. Check the Cutter motor for a failure. 2. Change the Cutter motor for a new one. Cutter unit Cutter unit 3. Check the Cutter motor connector cable for damage. 3. Change the Cutter motor for a new one. 1. Check the rail groove of the Cutter for paper dust, foreign matter, 1. Remove the paper dust, foreign matter, etc. etc. from the rail groove of the Cutter. 1. Check that the paper used is not other than the EPSON special media. 2. Check the Cutter for damage. 1. Use the EPSON special media. 2. Change the Cutter unit for a new one. TROUBLESHOOTING Troubleshooting 93