Epson 2200 Service Manual - Page 150

EPSON Stylus PHOTO 2100/2200 Revision B PG Change Lever PG Change Link Cutout and cutout support Figure 4-66. Removing the PG Change Link 4. Release the hook of the PG Change Bush from the Carriage Guide Shaft B, and remove the PG Change Bush and PG Change Link together from the Carriage Guide Shaft B. C A U T IO N Since the hook of the PG Change Bush is easily damaged, handle it very carefully. Refer to Figure 4-67, "Removing the PG Change Bush and PG Change Link". 5. Remove the one screw 9) C.B.S (P4) 3×6 (6±1kgf.cm) that secures the Sub Right Adjust Parallelism Bush, and while slightly pulling the bottom side (tooth surface) of the Sub Right Adjust Parallelism Bush to the front as viewed from the printer right side, turn it counterclockwise to release the two hooks, and then remove the Sub Right Adjust Parallelism Bush from the Right Frame. Hooks Sub Right Adjust Parallelism Bush C.B.S(P4)3×6 PG Change Bush Hook Carriage Guide Shaft B Figure 4-67. Removing the PG Change Bush and PG Change Link Figure 4-68. Removing the Sub Right Adjust Parallelism Bush DISASSEMBLY AND ASSEMBLY Disassembly 150