Epson 2200 Service Manual - Page 165
Removing the CR Encoder Sensor Board, Routing the FFC
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 165 highlights
EPSON Stylus PHOTO 2100/2200 To connect the FFC of the PW Sensor, pass it around the Arm of the PW Sensor Cover and the rear side of the Bearing on the left side (as seen from the printer front) of the Carriage Unit and into the hook on the rear left of the Carriage Unit, and return it between the hook and the Connector of the CR Encoder Sensor Board, and connect it to the Connector of the CR Encoder Sensor Board. Refer to Figure 4-100, "Routing the FFC". Arm Bearing Connector FFC Figure 4-100. Routing the FFC Hook A D JU S TM E N T R E Q U IR E D " When removing or changing the PW Sensor, the following adjustments are necessary. Make the adjustments in the following order. 1. PG adjustment 2. CR tooth skip prevention mechanism adjustment 3. Head cleaning 4. Head angular adjustment 5. Bi-D adjustment 6. Pixel Shift Adjustment 7. PW sensor mounting position adjustment " Refer to "Chapter 5 Adjustment" for the adjustment procedures. Revision B 4.2.12.6 Removing the CR Encoder Sensor Board 1. Remove the Carriage Unit. (Refer to 4.2.9.) 2. Remove the three screws 12) C.P.B (P1) 1.7×5 (1.5±0.25kgf.cm) that secure the CR Encoder Sensor Board. 3. Disconnect the FFC, which is connected to the CR Encoder Sensor Board, from the Connector, and remove the CR Encoder Sensor Board. 1 CR Encoder Sensor Board 2 3 C.P.B(P1) 1.7×5 Grounding Plate Connector FFC Hook Figure 4-101. Removing the CR Encoder Sensor Board DISASSEMBLY AND ASSEMBLY Disassembly 165