Epson 2200 Service Manual - Page 128
Disconnecting the Connector Cables and FFCs
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
EPSON Stylus PHOTO 2100/2200 3. Disengage the two Tie Wrap Bands and the hooks of the two Ferrite Cores secured to the Board Unit to release the Connector Cables and FFCs. Tie Wrap Bands Convexes Bottom rear side Figure 4-15. Disconnecting the Connector Cables and FFCs 4. Disconnect the Connector Cables and FFCs from the Main Board, and pull and remove the Board Unit from the Printer Mechanism again to the front as viewed from the printer rear. C A U T IO N Do not cut the Convexes that secure the Ferrite Cores to the Board Unit. Refer to Figure 4-15, "Disconnecting the Connector Cables and FFCs". Revision B " Connect the Connector Cables to the Connectors that match in colors and pin counts. " For the two wide FFCs, connect the one on the printer rear side to CN10 and the one on the front side to CN11. Refer to Figure 4-16, "Connection Destinations of Harnesses and FFCs". Printer rear CN10 Printer front CN11 Figure 4-16. Connection Destinations of Harnesses and FFCs " When reinstalling the Board Unit, fit the screws in the order shown in Figure 4-14. " When reinstalling the Board Unit, always bundle the Connector Cables and FFCs (narrow FFCs) with the Tie Wrap Bands and Ferrite Cores. Refer to Figure 4-15, "Disconnecting the Connector Cables and FFCs". DISASSEMBLY AND ASSEMBLY Disassembly 128