Epson 2200 Service Manual - Page 183
Joggle Supports That Secure the Cutter Housing, Screws That Secure the Cutter Sensors
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
EPSON Stylus PHOTO 2100/2200 Revision B 3. Pull and release the Joggle Supports, which secure the left and right of the Cutter Housing, to the front as seen from the Cutter Housing rear, and remove the Cutter Housing. Joggle Supports 4. Disconnect the Connector Cables (CN3, CN4) from the left and right Cutter Sensors. 5. Remove one (a total of two) screw 6) C.B.S 3×6 (9±1kgf.cm) that secures each of the left and right Cutter Sensors, and remove the Cutter Sensors. C.B.S 3x6 Connector C.B.S 3x6 Connector Figure 4-139. Joggle Supports That Secure the Cutter Housing When reinstalling the Cutter Housing, match the two inner screws with the screw holes of the Harness Clamp as viewed from the Cutter Housing rear. (This also applies to the left side.) Refer to Figure 4-140, "Reinstalling the Cutter Housing". Matched portion Cutter Sensor Cutter Sensor Figure 4-141. Screws That Secure the Cutter Sensors Before reinstalling each of the Cutter Sensors, match it to the two (a total of four) joggles. Refer to Figure 4-142, "Reinstalling the Cutter Sensors". Joggles Joggles Figure 4-140. Reinstalling the Cutter Housing Figure 4-142. Reinstalling the Cutter Sensors DISASSEMBLY AND ASSEMBLY Disassembly 183