Epson 2200 Service Manual - Page 143

EPSON Stylus PHOTO 2100/2200 12. Slide the Paper Eject Unit to the right as seen from the printer front, and then also move the Carriage Unit to the right end. 13. While pulling the Left Frame to the left as viewed from the printer front, pull out the left end of the Paper Eject Unit to the front. 14. Move the Carriage Unit to the left end as viewed from the printer front, pull the right end of the Paper Eject Unit out of the Right Frame, and remove it from the Printer Mechanism. " Make sure that the two Extension Springs 1.554 are fitted in the correct positions. Refer to Figure 4-48, "Removing the Extension Springs 1.554". " When reinstalling the Paper Eject Unit, make sure that the engagement portions with the Left and Right Frames are fitted properly. Refer to Figure 4-50, "Normal Positions of Paper Eject Unit Engagement Portions". Printer front Paper Eject Unit Normal position of left side engagement portion Normal position of right side engagement portion Figure 4-50. Normal Positions of Paper Eject Unit Engagement Portions " Connect the Connector Cable of the CD-R Sensor correctly using tweezers. Refer to Figure 4-47, "Removing the Front Frame". " Fix the Connector Cable of the CD-R Sensor correctly with the Tie Wraps in the Front Frame. Refer to Figure 4-47, "Removing the Front Frame". Revision B C A U T IO N " Make sure that the U-cut portion on the bottom of the Sub Shaft Mounting Plate located on the inner left side of the Carriage Guide Shaft B as seen from the printer front is installed properly since it may come off the cutout of the Left Frame during removal of the Paper Eject Unit. Refer to Figure 4-51, "Normal Position of the Sub Shaft Mounting Plate". Sub Shaft Mounting Plate U-cut portion Figure 4-51. Normal Position of the Sub Shaft Mounting Plate DISASSEMBLY AND ASSEMBLY Disassembly 143