Epson 2200 Service Manual - Page 140

EPSON Stylus PHOTO 2100/2200 Revision B 4.2.5 Removing the Paper Eject Unit 1. Remove the Printer Mechanism. (Refer to 4.2.1.4.) 2. Move the Release Lever to the far position to increase the platen gap to the maximum. 3. Remove the two screws 6) C.B.S 3×6 (9±1kgf.cm) that secure the Upper Housing Mounting Plate. Upper Housing Mounting Plate 4. Slide the Upper Housing Mounting Plate to the right as viewed from the printer front, and while turning the Upper Housing Mounting Plate toward the printer front, remove it from the Front Frame. Carriage Guide Shaft B C.B.S 3×6 Figure 4-41. Screws That Secure the Upper Housing Mounting Plate Notch Hook and cutout Notch Figure 4-42. Removing the Upper Housing Mounting Plate C A U T IO N When removing the Upper Housing Mounting Plate, fully be careful not to scratch the Carriage Guide Shaft B. Refer to Figure 4-42, "Removing the Upper Housing Mounting Plate". " When reinstalling the Upper Housing Mounting Plate, insert the Compression Spring 2.45 into the joggle in the center of the Paper Eject Unit. Refer to Figure 4-43, "Reinstalling the Upper Housing Mounting Plate". DISASSEMBLY AND ASSEMBLY Disassembly 140