Epson 2200 Service Manual - Page 133

EPSON Stylus PHOTO 2100/2200 5. With the Roll Paper Guide and ASF Unit viewed from the rear, pull the right end of the Roll Paper Guide to the right to remove it from the joggle on the ASF Unit right side, and then remove the Roll Paper Guide from the joggle on the ASF Unit left side. Revision B " When reinstalling the ASF Unit, insert the joggle under the left side, as viewed from the printer rear, into the Lower Frame, and the joggle on the rear side into the Front Frame, and make sure that the tooth surface of the Spur Gear 32 in the ASF Unit engages with the tooth surface of the Combination Gear 14, 28 in the DE Unit. Refer to Figure 4-27, "Reinstalling the ASF Unit 2". Joggle ASF Unit left side Joggle Joggle ASF Unit right side Figure 4-25. Removing the Roll Paper Guide " Before reinstalling the Roll Paper Guide, insert the joggle on the ASF Unit left side, as viewed from the ASF Unit rear, into the mounting hole of the Roll Paper Holder. Refer to Figure 4-25, "Removing the Roll Paper Guide". " Insert the round joggle on the ASF Unit front bottom right side, as viewed from the ASF Unit front, into the mounting hole of the Middle Frame located on the left of the printer center as viewed from the printer rear. Refer to Figure 4-26, "Reinstalling the ASF Unit 1". Combinati on Gear 14, 28 Mounting hole Middle Frame ASF Unit front bottom right side Spur Gear 32 Joggle Figure 4-26. Reinstalling the ASF Unit 1 ASF rear right side Joggle Figure 4-27. Reinstalling the ASF Unit 2 A D JU S TM E N T R E Q U IR E D When changing the ASF Unit, make the following adjustment. • PW sensor mounting adjustment DISASSEMBLY AND ASSEMBLY Disassembly 133