Epson 2200 Service Manual - Page 139

EPSON Stylus PHOTO 2100/2200 " Reinstall the Left and Right LD Roller Units so that the grooves on the rear side of the LD Roller Units engage the rail of the ASF Frame. Refer to Figure 4-38, "Reinstalling the LD Roller Units". " When reinstalling the Left LD Roller Unit to the Edge Guide bottom side of the Hopper, engage the rib of the Left LD Roller Unit with the groove of the Edger Guide as seen from the ASF Unit front. Refer to Figure 4-38, "Reinstalling the LD Roller Units". Edge Guide Rib Revision B " When reinstalling the ASF Sensor Wheel, Left and Right Hopper Cams and LD Roller, refer to Figure 4-40 and face the home position (notch) of the ASF Sensor Wheel, the cam diameters of the Left and Right Hopper Cams and the plane surface of the LD Roller face the same direction. Notch Groove Figure 4-38. Reinstalling the LD Roller Units " When reinstalling the Left and Right Hopper Cams, place them so that the markings of the Cams face rightward as viewed from the ASF Unit front. Refer to Figure 4-39, "Marking Position of the Hopper Cam". Figure 4-40. Phase Matching A D JU S TM E N T R E Q U IR E D " When changing the following parts for new ones, always apply grease G-26 to the specified places. • ASF Frame : Refer to Chapter 6, Figure 6-15, "Lubrication Point 17". • Hopper : Refer to Chapter 6, Figure 6-15, "Lubrication Point 17". Hopper Cam Marking Figure 4-39. Marking Position of the Hopper Cam DISASSEMBLY AND ASSEMBLY Disassembly 139