Epson 2200 Service Manual - Page 138

EPSON Stylus PHOTO 2100/2200 16. Remove the Compression Spring 3.13 that engages the Hopper and Left LD Roller Unit as seen from the ASF Unit front, and remove the Left LD Roller Unit from the Hopper. 17. Remove the Compression Spring 1.961 that engages the Hopper and Right LD Roller Unit as seen from the ASF Unit front, and slide the Right LD Roller Unit to the right to remove the Right LD Roller Unit from the Arm of the Hopper. Compression Spring 1.961 Compression Spring 3.13 Right LD Roller Unit Left LD Roller Unit Figure 4-36. Removing the LD Roller Units " Place the Compression Springs into the Left and Right LD Roller Units correctly. (Place the Compression Spring 1.961 on the right and the Compression Spring 3.13 on the left.) Refer to Figure 4-36, "Removing the LD Roller Units". Revision B " When reinstalling the Compression Spring that engages the Hopper and LD Roller Unit, pre-fix it to the hooks of the Spring Support in the LD Roller Unit. After installing it to the ASF Frame, release the hitched Spring from the rear hole in the ASF Frame. (This also applies to the Right LD Roller Unit.) Refer to Figure 4-37, "Installing the Compression Spring". Hooks Rear hole Figure 4-37. Installing the Compression Spring DISASSEMBLY AND ASSEMBLY Disassembly 138