Epson 2200 Service Manual - Page 161
Removing the Sensors
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
EPSON Stylus PHOTO 2100/2200 Revision B " When reinstalling the Torsion Springs 117.9, make sure that the Torsion Springs 117.9 are placed correctly in the spring setting positions of the Driven Roller Assembly (printer front). Refer to Figure 4-90, "Torsion Spring 117.9 Setting Position". Driven Roller Assembly 4.2.12 Removing the Sensors 4.2.12.1 Removing the PG Sensor and Release Sensor 1. Remove the Rear Housing. (Refer to 4.2.1.2.) 2. Disconnect the Connector Cables of the PG Sensor and Release Sensor from the Connectors of the PG Sensor and Release Sensor. 3. Release the two hooks that secure each of the PG Sensor and Release Sensor, and remove the PG Sensor and Release Sensor. PG Sensor Torsion Spring 117.9 Top center Figure 4-90. Torsion Spring 117.9 Setting Position A D JU S TM E N T R E Q U IR E D " After changing the following parts for new ones, always apply grease G-26 in the specified positions. • Release Lever Shaft: Refer to Chapter 6, Figure 6-11, "Lubrication Point 13". • Click Lever: Refer to Chapter 6, Figure 6-16, "Lubrication Point 18". • Release Lever, Release Connect Lever, Intermittent Gear 24, 30: Refer to Chapter 6, Figure 6-17, "Lubrication Point 19". Release Sensor Hooks Hooks Figure 4-91. Removing the PG Sensor and Release Sensor When reinstalling the PG Sensor and Release Sensor, locate the PG Sensor Connector Cable end, which is read, in the top right position, and the Release Sensor Connector Cable end, which is yellow, in the bottom left position. Refer to Figure 4-91, "Removing the PG Sensor and Release Sensor". DISASSEMBLY AND ASSEMBLY Disassembly 161