Epson 2200 Service Manual - Page 82

EPSON Stylus PHOTO 2100/2200 Revision B Occurrence Timing Phenomenon Detail At power-on At power-on, the Paper guide of the Printer mechanism is open and Release lever error is displayed. The Release lever is in the front position and the Paper guide is closed but Release lever error is displayed. Table 3-4. Phenomenon-Based Release Lever Error Check Points Faulty Part/ Part Name Check Point Remedy Release lever Release lever sensor 1. Check that the Release lever is not in the far position, or when the 1. Move the Release lever to the front or thick CD-R tray is not fitted (Only for Stylus PHOTO 2100), is not in paper printing position. the CD-R printing position. 2. Check that the Release lever is not in other than the CD-R printing position when the CD-R tray is fitted. (Only for Stylus PHOTO 2100) 2. Move the Release lever to the CD-R printing position. (Only for Stylus PHOTO 2100) 1. Check that the Release lever sensor connector cable is connected 1. Connect the Release lever sensor connector to the Release lever sensor and Main board (CN1) securely. cable to the Release lever sensor and Main board (CN1) securely. Release lever sensor 2. Move the Release lever sensor detection lever manually in the same state as when the Release lever makes contact with the Detection lever, and check that the Detection lever returns to the original position automatically when released. 3. Using a tester, check that the Release lever sensor is normal. • Connector (CN1) Open Not open : 3.3V : 0V 2. Change the Release lever sensor for a new one. 3. Change the Release lever sensor for a new one. TROUBLESHOOTING Troubleshooting 82