Epson 2200 Service Manual - Page 201
PG Adjustment Method
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 201 highlights
EPSON Stylus PHOTO 2100/2200 Revision B 5.2.4.1 PG Adjustment Method 1. When replacing the Printhead, make sure that there is no Shipping Liquid sticking on the Head surface, and then install the Head on the Carriage unit. 5. Press the jig setting position movement button in the servicing adjustment program. CHECK P O IN T When removing/reinstalling the Printhead, completely wipe the drops of ink off the metal frame section on the Head nozzle surface with the ASP cleaner blade, which was kept clean, or a clean, soft cloth (cloth that will not fluff), and then install the Printhead to the Carriage unit. C A U T IO N If the drops of ink and Shipping Liquid have stuck to the Head nozzle surface or Nozzle plate metal frame, fully be careful since the PG cannot be adjusted accurately due to continuity that occurs before contact of the Nozzle plate metal frame and gauge adjustment portions. 2. Remove the Printer mechanism together with the Board unit from the Lower housing, and place it on a level base. CHECK P O IN T " Before starting PG adjustment, load all Ink cartridges into the CR unit. If the Ink cartridges have not been loaded, the CR weight will be instable and the PG may not be adjusted properly. " After removing the Printer mechanism, place a rag or ASP waste ink pad under the Waste ink tube to prevent the desk from being contaminated. " Put the Printer mechanism on the flat stable work table. If you adjust the PG on the unstable table that the suface is not flat, the PG adjustment is affected by the table condition and the PG can not be adjusted correctly even if the adjustment lever over the adjusment range. So, after put the Printer mechanism on the table, check that the printer dose not move rumbly by shaking the mechanism on the table. 3. Loosen the screws of the Adjust parallel bushes and Sub adjust parallel bushes. 4. Place the Release lever in the envelope mark position to increase the PG. Figure 5-10. Adjustment Program 6. Screw the left and right PG gauge lead wires or arms to the Gauges, and matching the Adjustment gauges to their respective edges, set them in the specified positions (left end/right end of the rib on the Paper guide). At this time, make sure that the Adjustment gauges are installed securely and evenly. Gauge adjustment plates Setting positions Figure 5-11. Adjustment Gauge Setting Positions 7. Press the right main shaft adjustment position movement button in the adjustment program to move the Carriage to the PG main shaft right adjustment position. ADJUSTMENT Adjustments 201