Epson 2200 Service Manual - Page 160

EPSON Stylus PHOTO 2100/2200 When reinstalling the PG Change Spring Lever, Intermittent Gear 24, 30 and Release Connect Lever, always match the phase marks that are also shown in the left photo in Figure 4-86. Revision B 6. Releasing the Torsion Springs 117.9 that secure the Driven Rollers as viewed from the printer rear disengages the Release Lever Shaft from the hooks on the Frame. Torsion Springs 117.9 CHECK P O IN T The C Ring that secures the Release Connect Lever is larger than the C Ring that secures the PG Change Lever. Refer to Figure 4-86, "Removing the Gears". C A U T IO N When removing the Release Connect Lever, fully be careful not to lose the Parallel Pin since it may come off. Refer to Figure 4-86, "Removing the Gears". 5. Remove the one screw 6) C.B.S 3×6 (9±1kgf.cm) that secures the Cover on the right end of the Release Lever Shaft as seen from the printer rear, pull the right end of the Cover to the front to release the hook on the left end of the Cover, and remove the Cover. Release Lever Shaft Cover Driven Rollers Figure 4-88. Releasing the Torsion Springs 117.9 7. Pull the Release Lever Shaft to the right, as seen from the printer rear, to remove. " When reinstalling the Release Lever Shaft, face the round part of its end downward, and then turn it counterclockwise to face the round part upward. Refer to Figure 4-89, "How to Install the Release Lever Shaft". Round part Printer rear left side C.B.S 3×6 Figure 4-87. Removing the Cover DISASSEMBLY AND ASSEMBLY Figure 4-89. How to Install the Release Lever Shaft Disassembly 160