Epson 2200 Service Manual - Page 149
Removing the Carriage Guide Shaft B, Removing the PG Change Spring Link
![]() |
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
EPSON Stylus PHOTO 2100/2200 Revision B CHECK P O IN T " The ASP structure of the Head FFC Guide is the Head FFC Guide, Sponge, Ferrite Core and double-faced tape. When changing the Head FFC Guide, reinstall it after making sure that the Sponge and Ferrite Core are fitted in the correct positions. Leave a 0 to 2mm clearance above the Sponge and Frame. Sponge 4.2.8 Removing the Carriage Guide Shaft B 1. Remove the Printer Mechanism. (Refer to 4.2.1.4.) 2. Slightly slide the Carriage Unit to the left as viewed from the printer front, move the Release Lever to the thick paper print position, and remove the PG Change Spring Link from the PG Change Lever. PG Change Spring Link Ferrite Core Figure 4-64. Normal Position of Ferrite Core PG Change Lever Figure 4-65. Removing the PG Change Spring Link 3. Turn the PG Change Bush and PG Change Lever clockwise as seen from the printer right side until the shape of the cutout in the right end of the PG Change Link matches that of the cutout in the PG Change Lever. Then, pull the PG Change Lever to the front and remove the cutout of the PG Change Link. DISASSEMBLY AND ASSEMBLY Disassembly 149
![](/manual_guide/products/epson-2200-service-manual-fb9e030/149.png)