Epson 2200 Service Manual - Page 205

EPSON Stylus PHOTO 2100/2200 Revision B 3. Before moving the Adjust lever, remove the Ink cartridges, loosen the two screws that secure the I/C spring and Head fastener, and remove the Torsion spring on the left of the CR. I/C spring 6. Execute Steps 1 to 5 until the black and light magenta rules are at uniform intervals. CHECK P O IN T When moving the Head angular adjust lever again after checking the adjustment result, always remove the Ink cartridges, loosen the Head fastener fixing screws, and then move the Adjust lever. Torsion spring Head fastener left fixing screw Head fastener right fixing screw Figure 5-17. Head Fastener Fixing Screws and Torsion Spring 4. Refer to Figure 5-16 and move the Adjust lever, and while pressing both ends of the Head fastener against the far side of the CR, tighten the fixing screws. Figure 5-18. Head Fastener Fixing Method 5. Fit the Ink cartridges, print the Head tilt adjustment pattern, and check the adjustment result. ADJUSTMENT Adjustments 205