Epson 2200 Service Manual - Page 142

EPSON Stylus PHOTO 2100/2200 7. Pull the Front Frame from the Printer Mechanism to the front as seen from the printer front, disconnect the Connector Cable of the CD-R Sensor, release the Connector Cable from the two Tie Wraps, and remove the Front Frame. Revision B 8. Remove the Extension Springs 1.554 that engage the Paper Eject Unit and Left and Right Frames. Hook Paper Eject Unit Hook CD-R Sensor Cable Tie Wraps Figure 4-47. Removing the Front Frame When reinstalling the Front Frame, insert the three joggles into the Front Frame securely. Refer to Figure 4-46, "Screws That Secure the Front Frame". Left Frame side Extension Springs 1.554 Right Frame side Figure 4-48. Removing the Extension Springs 1.554 9. Move the Carriage Unit to the center. 10. Slide the Paper Eject Unit once to the left as seen from the printer front to release the two left and right engagement portions of the Paper Eject Unit. 11. Slide the Paper Eject Unit to the rear as viewed from the printer front, slightly lift the front side to release the right-hand side hook from the center, and raise the left and right hooks of the Paper Eject Unit and the cutout in the right center side to above the notches of the left and right engagement portions and the right center side hook. 3 2 3 2 1 1 Engagement portion Hook Engagement portion Figure 4-49. Removing the Paper Eject Unit 1 DISASSEMBLY AND ASSEMBLY Disassembly 142