Epson 2200 Service Manual - Page 176

EPSON Stylus PHOTO 2100/2200 Revision B " Place the two Compression Springs 0.65, which are located on the lower side of the Rear Paper Guide as seen from the printer rear, into the recesses of the Under Frame, and reinstall the Rear Paper Guide. Refer to Figure 4-126, "Positions of the Compression Springs 0.65". 6. Remove the Extension Spring 9.65 from the PF Roller Support. Compression Springs 0.65 Figure 4-126. Positions of the Compression Springs 0.65 " Securely fitted into the joggles on the left and right lower sides of the Rear Paper Guide, the Compression Springs 0.65 are designed to be difficult to come off. If they have come off, however, securely insert them into the joggles on the lower side of the Rear Paper Guide. Refer to Figure 4-126, "Positions of the Compression Springs 0.65". C A U T IO N When removing and reinstalling the Rear Paper Guide, also be fully careful not to peel off the coating of the PF Roller. Refer to Figure 4-123, "Removing the Front Paper Guide". Hook Under Driven Roller Extension Spring 9.65 PF Roller Support Lever Figure 4-127. Removing the Extension Spring 9.65 7. Remove the Grounding Spring that engages the PF Roller and Rear Frame. 8. Release the joggle of the Bush 12 from the Left Frame, and after turning it to the front as seen from the printer front, slide the PF Roller to the left. Bush 12 Joggle Grounding Spring PF Roller 5. In order not to bring the Driven Roller and PF Roller surface into contact with each other, place the Release Lever in the far position. Figure 4-128. Removing the PF Roller DISASSEMBLY AND ASSEMBLY Disassembly 176