Epson 2200 Service Manual - Page 221

EPSON Stylus PHOTO 2100/2200 Table 6-2. Lubrication Points Ref. No. Lubrication Type/Point Remarks ! Holes of right parallelism adjust bush and subright parallelism adjust bush 22 ! G-26 ! Entire periphery of inside diameter Apply grease to the entire periphery. Refer to Figure 6-20. ! Refer to Figure 6-21. Portions where both sides of the CR guide shaft B make contact with the Slider CR ! G-56 ! 1) φ3mm x 30mm: CR guide shaft B left side ! Place the Adjust lever in the front side position, move the Carriage unit to the center, and apply grease from both ends of the Carriage unit to between both ends of 2) φ3mm x 30mm: CR guide shaft B right side 23 the Housing upper fixing frame. ! Place the Release lever in the far side position, move the left end of the Carriage unit from the left end of the Housing upper fixing frame to a +/- 30mm position, and apply grease. C A U T IO N " Never lubricate the CR guide shaft A directly. Doing so will give critical faults to the main components of the printer. " Never apply an excessive amount of oil to the oil pad. Doing so will give critical faults to the main components of the printer. MAINTENANCE Overview Revision B G-26 Figure 6-3. Lubrication Point 1 G-26 Right side G-26 G-26 Figure 6-4. Lubrication Point 2 221