Epson 2200 Service Manual - Page 123

EPSON Stylus PHOTO 2100/2200 4.2.1.2 Removing the Rear Housing 1. Remove the three screws 2) C.B.S 3×10 (9±1kgf.cm) that secure the Rear Housing. Hooks C.B.S 3×10 Rear Housing Figure 4-7. Screws That Secure the Rear Housing 2. Lower the Release Lever in advance. While pulling down the three cutouts, which secure the bottom of the Rear Housing as seen from the printer rear, one by one, release them from the Rear Housing. Push the two hooks, which secure the left and right, one by one toward the printer inside to pull them out of the Lower Housing, and remove the Rear Housing from the printer using the two upper hooks as supports. Revision B C A U T IO N Fully take care when releasing the three lower cutouts since they whiten easily. Especially as the cutout on the bottom left side as viewed from the printer rear whitens more easily than the others. The recommended disassembling procedures are as follows. " Remove the right side hook figured on 2 in the Figure4-8 by pushing the blue circuled portion strongly. Then remove the right bottom (red circuled portion on 2 in the Figure4-8. " Then, remove the right side of the Rear housing and remove the center bottom cutout carefully. " After that, while pulling the Rear housing downward, remove the left side hook figured on 1 in the Figure4-8 by pushing the blue circuled portion strongly. By pulling the Rear housing downward, the left bottom cutout portion is easily released fron the bottom housing. Hook 1 2 Hook Printer bottom 3 4 DISASSEMBLY AND ASSEMBLY Cutouts Figure 4-8. Hooks and Cutouts That Secure the Rear Housing Disassembly 123