Epson 2200 Service Manual - Page 129

EPSON Stylus PHOTO 2100/2200 Revision B 4.2.2.3 Removing the Main Board 1. Remove the Board Unit. (Refer to 4.2.2.2.) 2. Disconnect the Connector Cable from CN15 of the Main Board. CHECK P O IN T " CN15 has a connector cable lock mechanism. Therefore, before disconnecting the Connector Cable, make sure that the lock mechanism has been cleared. When reconnecting the cable, insert the pins correctly into the corresponding ports of CN15. Refer to Figure 4-17, "Connector Cable Lock Mechanism". " Mount the pin side, where a blue line is drawn on the Connector Cable, to the 1 pin side. Refer to Figure 4-17, "Connector Cable Lock Mechanism". Blue line 1 2 1 pin side 1 CN15 3. Remove the five screws 6) C.B.S 3×6 (9±1kgf.cm) and three screws 7) C.P 3×6 (6±1kgf.cm) that secure the Main Board, and remove the Main Board. Main Board 1 3 C.B.S 3×6 C.P 3×6 2 5 4 Figure 4-18. Screws That Secure the Main Board Fit the screws 6) C.B.S 3×6 in the order shown in Figure 4-18. Figure 4-17. Connector Cable Lock Mechanism DISASSEMBLY AND ASSEMBLY Disassembly 129