Epson 2200 Service Manual - Page 141

EPSON Stylus PHOTO 2100/2200 " Insert the cutouts in the left and right of the Upper Housing Mounting Plate into the notches of the Front Frame, and hitch the cutout of the Upper Housing Mounting Plate on the notch in the center of the Front Frame. Refer to Figure 4-42, "Removing the Upper Housing Mounting Plate". Compression Spring 2.45 Revision B " When reinstalling the Cutter Support, insert the four joggles securely to fix the Cutter Support. Refer to Figure 4-44, "Screws That Secure the Cutter Support". " After reinstalling the Cutter Support, make sure that it is in the normal position since the Paper Eject Unit left side may come off the engagement portions with the Left and Right Frames and shift to the printer left side during installation of the Cutter Support. Refer to Figure 4-45, "Normal Positions of Paper Eject Unit Engagement Portions". Printer front Front Frame rear center Joggle Figure 4-43. Reinstalling the Upper Housing Mounting Plate 5. Remove the three screws 6) C.B.S 3×6 (9±1kgf.cm) that secure the Cutter Support, and remove the Cutter Support from the Printer Mechanism. Joggle Cutter Support C.B.S 3×6 Paper Eject Unit Normal position of left side engagement portion Normal position of right side engagement portion Figure 4-45. Normal Positions of Paper Eject Unit Engagement Portions 6. Remove the three screws 6) C.B.S 3×6 (6±1kgf.cm) that secure the Front Frame. Front Frame Joggle Joggle Joggles Joggles Figure 4-44. Screws That Secure the Cutter Support C.B.S 3×6 C.B.S 3×6 Figure 4-46. Screws That Secure the Front Frame DISASSEMBLY AND ASSEMBLY Disassembly 141