Epson 2200 Service Manual - Page 232
Table 7-16., EEPROM Address Map, Address, Explanation, Setting, Factory
![]() |
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
EPSON Stylus PHOTO 2100/2200 Revision B Table 7-16. EEPROM Address Map Address Explanation Setting QPIT Factory setting settings 38H 39H Replace Cleaning Counter 00H 00H 00H 00H 3AH Initial Fill Counter 00H 00H 3BH Reserved - - 3CH Fatal Error Code 00H 00H 3DH Total fever (CR) 00H 00H 3EH Total fever (PF) 00H 00H 3FH Roll paper flag bit0: Roll paper mode bit1: Panel load mode 00H 00H 40H 41H Password 5AH 0FH - 42H EEPROM mapping revision 41H - 43H Reserved - - 44H Interface selection 0:Auto 4:1394 1:Parallel 3:USB1.1 5:USB2.0 00H 00H(*2) 45H Interface time-out 0 to 255 (by second, value of 0 means 10 seconds) 0AH 0AH 46H Compatibility speed 0:Fast 2:Special-1 1:Slow 3:Special-2 00H 00H 47H ECP speed (*a) 0:Fast 1:Slow 00H 00H 48H IEEE1284.4 for Parallel 0:Auto 2:Off 1:On 00H 01H 49H IEEE1284.4 for USB 0:Auto 2:Off 1:On 00H 01H *a. BUSY signal delay time from fall-edge of a -STB signal. (Fast:Max.1MB/s, Slow:Max. 600KB/s) *b. Select IEEE1284 transfer mode. (ECP or Nibble) *c. Enable or disable reverse transfer. (when disabled, ignore -SLIN signal) Table 7-16. EEPROM Address Map Address Explanation Setting 4AH I/F Control flags bit0: bit1: bit2-bit7: IEEE1284 mode (0=On, 1=Off)(*c) ECP mode (0=Off, 1=On)(*b) reserved 4BH | Reserved 4FH 50H | CPSI password 55H 56H Print direction control 0:Bi-D 2:Auto 1:Uni-D 57H CG table 08H:PC437 0AH:PC850 58H Font 0:Courier 59H Pitch 0:10cpi bit0: 5AH Auto LF, Network I/F mode bit1: bit2-bit7: Auto line feed (0=Off,1=On) Network I/F mode (0=Off,1=On) reserved 5BH Check mod control 0:Entry Self-Test 1:Entry Hex-Dump 2:Extended settings 5CH PW Adjustment (HMXU) -8
![](/manual_guide/products/epson-2200-service-manual-fb9e030/232.png)