Epson 2200 Service Manual - Page 175

EPSON Stylus PHOTO 2100/2200 4.2.15 Removing the PF Roller 1. Remove the Paper Eject Roller Shaft B. (Refer to 4.2.6.) 2. Remove the Carriage Unit. (Refer to 4.2.9.) 3. Release the three hooks, which secure the front side of the Front Paper Guide as seen from the printer front, from the Paper Eject Roller Shaft A, and while lightly pulling the Front Paper Guide to the front, turn it upward to release the rear left side hook of the Front Paper Guide, and remove the Front Paper Guide. Hook PF Roller Front Paper Guide Revision B Bring the Grounding Plate, which is located on the bottom right side of the Front Paper Guide as seen from the printer front, into contact with the Frame in advance. Refer to Figure 4-124, "Position of the Grounding Plate". Grounding Plate Hooks Figure 4-123. Removing the Front Paper Guide C A U T IO N Fully be careful when removing the Front Paper Guide, since the paper loading accuracy will reduce if the coating on the PF Roller surface peels off. This also applies to reinstallation. Refer to Figure 4-123, "Removing the Front Paper Guide". Figure 4-124. Position of the Grounding Plate 4. Release the three hooks, which secure the Rear Paper Guide as seen from the printer rear, from the Under Frame, release the two hooks that engages with the PF Roller, and remove the Rear Paper Guide. Rear Paper Guide Hooks Hooks PF Roller Figure 4-125. Removing the Rear Paper Guide DISASSEMBLY AND ASSEMBLY Disassembly 175