Epson 2200 Service Manual - Page 159

EPSON Stylus PHOTO 2100/2200 CHECK P O IN T When you remove the two screws that secure the Cap Unit and carry out Step 4, you can remove the Cap Unit without removing the Ink System Unit. Refer to Figure 4-83, "Removing the Ink System Unit" and Figure 4-84, "Removing the Cap Unit". Revision B 4.2.11 Removing the Release Lever Shaft 1. Remove the Printer Mechanism. (Refer to 4.2.1.4.) 2. Remove the ASF Unit. (Refer to Steps 2 to 4 in 4.2.4.) 3. Move the Release Lever to the thick paper printing position, and remove the PG Change Spring Link from the PG Change Spring Lever. DISASSEMBLY AND ASSEMBLY PG Change Spring Link PG Change Spring Lever Figure 4-85. Removing the PG Change Spring Link 4. Before removing the PG Change Spring Lever and Release Connect Lever, remove the C Ring, and then remove the PG Change Spring Lever, Intermittent Gear 24, 30 and Release Connect Lever in this order. Release Connect Lever C Ring C Ring Printer right side Intermitte nt Gear 24,30 Parallel Pin Figure 4-86. Removing the Gears Disassembly 159