Epson 2200 Service Manual - Page 220
Lubrication Type/Point, Remarks, Replacement of Oil
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
EPSON Stylus PHOTO 2100/2200 Table 6-2. Lubrication Points Ref. No. Lubrication Type/Point Remarks ! Oil pad ring ! O-12 ! 0.22cc 16 ! Lubricate only at the following timings. • Replacement of Carriage unit • Replacement of Oil pad ring ! Pour the specified oil in a clean pan-shaped vessel and immerse the pad there for 1 minute. ! After lubrication, leave the pad ring to stand for 1 minute, and mount it to the carriage unit with the lubricated surface located on the CR guide shaft side. Refer to Figure 6-14. ! Refer to Figure 6-15. Feed roller assembly mounting hole in the right side of the ASF frame ! G-26 ! Entire periphery of inside diameter 17 ! Refer to Figure 6-15. Portion that slides with the Release hopper lever of the Hopper assembly (2 places) ! G-26 ! φ1mm x 10mm x 2 points Revision B Table 6-2. Lubrication Points Ref. No. Lubrication Type/Point Remarks ! PG change spring lever mounting hole outside diameter 18 ! G-26 ! φ1mm x entire periphery of outside diameter Place the adjust lever in the far side position and apply grease. Refer to Figure 6-16. ! Tooth surfaces of Release levers and Release connection lever ! G-26 19 ! 1) Release connection lever: φ1mm x entire periphery of tooth surface 2) Release lever (front side): φ1mm x 3/4 tooth surface 3) Release lever (far side): φ1mm x 10mm Place the Release levers in the front and far side positions and apply grease. Refer to Figure 6-17. ! Combination gear 17, 24.5 bearing ! 20 G-26 ! φ1mm x 5mm Refer to Figure 6-18. ! Holes of left parallelism adjust bush and sub-left parallelism adjust bush Apply grease to the entire periphery. Refer to Figure 6-19. 21 ! G-26 ! Entire periphery of inside diameter MAINTENANCE Overview 220