Epson 2200 Service Manual - Page 215

EPSON Stylus PHOTO 2100/2200 Revision B 6.1 Overview This section provides information to maintain the printer in its optimum condition. 6.1.1 ROM Replacement This printer may require the ROM to be replaced when program changes or additions are made. In such cases, use the special tool (ROM puller: 2035659 (#F749)) to replace the ROM. The position of the ROM is shown in the figure below. ROM C387 MAIN Board Figure 6-1. ROM Location When installing the ROM into the socket, fit the glossy "#"-marked edges on the four corners of the ROM into the notches of the socket. 6.1.2 Cleaning This printer has no mechanical components which require regular cleaning except the printhead. Therefore, when returning the printer to the user, check the following parts and perform appropriate cleaning if stain is noticeable. C A U T IO N " " " " " " ! Housing Never use chemical solvents, such as thinner, benzine, and acetone to clean the exterior parts of the printer like the housing. These chemicals may deform the components of the printer or deteriorate the quality of the printer. Be careful not to damage any components when you clean inside the printer. Do not scratch the surface of the PF roller assembly. Use a soft brush to wipe off dust. Use a soft cloth moistened with dilute alcohol to remove ink stain. Do not use the supplied cleaning sheet for normal usage. It may damage the coated surface of the PF roller. If the adhesive surface of the cleaning sheet is set to the ASF LD roller side and used to clean the ASF LD roller surface, it is no problem. Use a clean soft cloth moistened with water and wipe off any dirt. If the Housings are stained with ink, use a cloth moistened with neutral detergent to wipe it off. ! Inside the printer Use a vacuum cleaner to remove any paper dust. MAINTENANCE Overview 215