Epson 2200 Service Manual - Page 185
Removing the Driver Board, Connector Cable Lock Mechanism
UPC - 010343841840
View all Epson 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
EPSON Stylus PHOTO 2100/2200 Revision B 4.2.18.3 Removing the Driver Board 1. Remove the Cutter Housing. (Refer to Steps 1 and 2 in 4.2.18.1.) 2. Disconnect all Connector Cables from the Driver Board. CHECK P O IN T " CN2 has a connector cable lock mechanism. Therefore, before disconnecting the Connector Cable, make sure that the lock mechanism has been cleared. When reconnecting the cable, insert the pins correctly into the corresponding cutouts of CN2. Refer to Figure 4-145, "Connector Cable Lock Mechanism". " Mount the pin side, where a blue line is drawn on the Connector Cable, to the 1 pin side. Refer to Figure 4-145, "Connector Cable Lock Mechanism". 2 1 CN2 Blue line 1 pin side 1 Figure 4-145. Connector Cable Lock Mechanism 3. Remove the two screws 6) C.B.S 3×6 (9±1kgf.cm) that secure the Board Plate and Driver Board. 4. Slide the Board Plate and Driver Board together to the left as viewed from the Cutter Unit front to release the two hooks, and after removing the Board Plate and Driver Board from the Cutter Unit, remove the Driver Board from the Board Plate. C.B.S 3×6 Notches Board Plate Driver Board Hooks C.B.S 3×6 Figure 4-146. Removing the Driver Board Insert the Driver Board into the notches of the Board Plate. Refer to Figure 4-146, "Removing the Driver Board". DISASSEMBLY AND ASSEMBLY Disassembly 185