Epson 2200 Service Manual - Page 146

EPSON Stylus PHOTO 2100/2200 4.2.7 Removing the Printhead 1. Remove the Middle Housing. (Refer to 4.2.1.3.) 2. Remove the Ink Cartridges. 3. Pull and release the two left and right joggles, which secure the I/C Cover to the Carriage Unit, inward and remove the I/C Cover from the Carriage Unit. Revision B 4. Move the Carriage Unit to the printer center. 5. Release the four hooks that secure the Head Cable Holder to the Carriage Unit, and lift and remove the Head Cable Holder from the Carriage Unit. Head Cable Holder Carriage Unit rear Joggles I/C Cover Figure 4-56. Removing the I/C Cover Hooks Hooks Figure 4-57. Removing the Head Cable Holder 6. Release the Torsion Spring 66 from the hook of the Head Fastener. 7. Remove the two screws 8) C.B.P 3×6 (6±1kgf.cm) that secure the Head Fastener. Torsion Spring 66 Head Fastener Hook Carriage Unit left side C.B.P 3×6 Carriage Unit right side Figure 4-58. Removing the Screws That Secure the Head Fastener DISASSEMBLY AND ASSEMBLY Disassembly 146