Epson 2200 Service Manual - Page 71

EPSON Stylus PHOTO 2100/2200 Revision B Printer Condition Release Lever Error Indicators Power Paper - High speed Blink Table 3-1. Error Indications and Fault Occurrence Causes Ink 1-7 - EPSON Printer Window 3 Fault Occurrence Cause This error is detected in the following case. The Release lever is in the release position, or when the CD-R tray is not fitted (Only for Stylus PHOTO 2100), in the CD-R printing position. Paper Out Error - On - "-" Blink Blink 2 : don't care : 0.5sec on + 0.5sec off repetition : 0.2sec on + 0.2sec on + 0.2sec on 0.4sec off repetition High speed Blink Blink alternately 1 Blink alternately 2 This error is detected in any of the following cases. 1. The paper is not set to the right Edge guide. 2. The PE sensor cannot detect the lower end of the paper in paper feeding operation. 3. When the CD-R tray was fitted, the CD-R was not detected and the Tray was ejected. (Only for Stylus PHOTO 2100) 4. The CD-R tray home position was not detected properly and the Tray was ejected. (Only for Stylus PHOTO 2100) : 0.1sec on + 0.1sec off repetition : 0.5sec on + 0.5sec off repetition : 0.5sec on + 0.5sec on repetition TROUBLESHOOTING Error Indications and Fault Occurrence Causes 71